« previous next »
Pages: [1]

Author Topic: Yoke binding  (Read 783 times)

yukonranger

Yoke binding
« on: May 04, 2022, 10:57:32 PM »
My yokes were removed for an instrument panel replacement and new avionics. Following reinstalation, there is a lot of friction when the yokes slide in and out. The nylon blocks the shafts travel look symmetrical but perhaps they are not(?). Any ideas to try?  Thanks
Logged

TreeTopFlyer

Re: Yoke binding
« Reply #1 on: May 06, 2022, 05:14:11 PM »
Get food grade silicone spray and lube them up!
Logged

Jason Stephens

Re: Yoke binding
« Reply #2 on: May 11, 2022, 10:24:46 AM »
Maybe the yokes were swapped or the alignment was changed during install that results in them binding on the bushing?  You could always remove one and then the other to see if its the right or left causing the issue.
Logged

xeyes

Re: Yoke binding
« Reply #3 on: August 19, 2022, 11:44:28 AM »
Cable tension
Logged
Pages: [1]
« previous next »